EndRun Meridian II, User Manual

Page: 42 / 240

M e r i d i a n I I U s e r M a n u a l 22
C H A P T E R T H R E E
23 M e r i d i a n I I U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
ptpconfig0
ptpconfig1
(optional)
Interactive script that guides you in configuring parameters for
the optional PTP/IEEE-1588 protocol. See Chapter 9 - PTP/
IEEE-1588
for more information.
ptpstat0
ptpstat1
(optional)
Prints the status of the optional PTP/IEEE-1588 Subsystem.
See
Chapter 9 - PTP/IEEE-1588
for more information.
pwrfltmask
(optional)
Prints the current settings of the optional Dual Power Supply
Input Fault Alarm Masks. See Chapter 10 - Rear-Panel I/O,
Power Supply Options
for more information.
rcvrserialnumber Prints the serial number of the GPS Receiver.
rcvrstat Prints the status of the GPS Receiver.
rcvrversion Prints the GPS Receiver firmware and FPGA version informa-
tion.
resetlastgpswn For use with a GPS simulator. See
Appendix J - Operation
with a GPS Simulator .
resetleaphistory For use with a GPS simulator. See
Appendix J - Operation
with a GPS Simulator .
rticmode
(optional)
Prints the mode of the RTIC Option - either ON or OFF. See
Chapter 11 - Real-Time Ionospheric Corrections for more
information.
serialnumber Prints the serial number of the Meridian II.
setantfltmask Command to enable or mask the Antenna Fault.
See the
antfltmask
command.
setcaldelay An interactive utility that allows you to change the clock cali-
bration delay. See the
caldelay
command.
setgpsdynmode Command to set the dynamic mode of operation of the GPS
Subsystem. See the
gpsdynmode
command.
setgpsrefpos Interactive utility that prompts you for an accurate reference
position, performs syntax and argument validity checking then
passes the position to the GPS Subsystem.
See the
gpsrefpos
command.
setinhibitoutputsmode Sets the InhibitOutputsMode setting which controls the timing
output signals (time codes and pulse rates) prior to initial lock
to GPS.
See the
inhibitoutputsmode
command.
setpwrfltmask
(optional)
Command to enable or mask the optional Dual Power Supply
Input Faults. See Chapter 10 - Rear-Panel I/O, Power Supply
Options
for more information.
setrticmode
(optional)
Sets the RTIC mode - either ON or OFF. See Chapter 11 -
Real-Time Ionospheric Corrections
for more information.
setsigfltmask Command to enable or mask the Signal Loss Fault.
See the
sigfltmask
command.
settfomfltlvl Command to change the TFOM fault level
sigfltmask Prints the current setting for the Signal Loss Fault mask.
See the
setsigfltmask
command.