Turbimax W CUS65
Troubleshooting
Hauser
15
8
Troubleshooting
8.1
Troubleshooting instructions
Troubleshooting must take account of the whole measuring system:
• Transmitter
• Electrical leads and connectors
• Assembly
• Sensor
The possible causes of failure listed in the following table primarily refer to the sensor.
!
Note!
Please pay special attention to the instructions on handling errors in the Operating Instructions of
the transmitter. Check the transmitter, if necessary.
8.2
Return
If the sensor has to be repaired, please return it
cleaned
to the sales center responsible.
Please use the original packaging, if possible.
Please enclose the completed "Declaration of Hazardous Material and De-Contamination" (copy the
second last page of these Operating Instructions) with the packaging and the transportation
documents.
No repair without completed declaration!
8.3
Disposal
The device contains electronic components and must therefore be disposed of in accordance with
regulations on the disposal of electronic waste.
Please observe local regulations.
Problem
Check
Remedy
No display, no sensor
reaction
Mains voltage at transmitter?
Sensor connected correctly?
Film formation on optical windows?
Connect mains voltage.
Set up correct connection.
Clean the sensor.
Reading too high or
too low
Film formation on optical windows?
Sensor calibrated?
Clean the sensor.
Calibrate.
Reading greatly
fluctuating
Check mounting location.
Select other mounting location.
