Basic safety instructions
Turbimax CUS50D
6
Hauser
2
Basic safety instructions
2.1
Requirements for personnel
• Installation, commissioning, operation and maintenance of the measuring system may be
carried out only by specially trained technical personnel.
• The technical personnel must be authorized by the plant operator to carry out the specified
activities.
• The electrical connection may be performed only by an electrical technician.
• The technical personnel must have read and understood these Operating Instructions and
must follow the instructions contained therein.
• Faults at the measuring point may only be rectified by authorized and specially trained
personnel.
Repairs not described in the Operating Instructions provided must be carried out only
directly at the manufacturer's site or by the service organization.
2.2
Designated use
The sensor is used to measure turbidity and solids and is specially designed for use in
industrial wastewater and processes.
The sensor is particularly suited for use in the following applications:
• Turbidity measurements based on the principle of light attenuation (turbidimetry) in
accordance with EN ISO 7027
• Absorption measurements in liquid, as well as highly absorbing media and sludges
• Measurement of concentration or solids content
• Measurement of solids content in process liquids
Use of the device for any purpose other than that described, poses a threat to the safety of
people and of the entire measuring system and is therefore not permitted.
The manufacturer is not liable for damage caused by improper or non-designated use.
2.3
Workplace safety
As the user, you are responsible for complying with the following safety conditions:
• Installation guidelines
• Local standards and regulations
Electromagnetic compatibility
• The product has been tested for electromagnetic compatibility in accordance with the
applicable international standards for industrial applications.
• The electromagnetic compatibility indicated applies only to a product that has been
connected in accordance with these Operating Instructions.
2.4
Operational safety
Before commissioning the entire measuring point:
1. Verify that all connections are correct.
