Proline Promag W 500 PROFINET
Electrical connection
Hauser
53
7.2.2
Connecting the transmitter
1
2 3
4
5
6
A0028200
1
Terminal connection for supply voltage
2
Terminal connection for signal transmission, input/output
3
Terminal connection for signal transmission, input/output
4
Terminal connection for connecting cable between sensor and transmitter
5
Terminal connection for signal transmission, input/output or terminal connection for network connection via
service interface (CDI-RJ45); optional: connection for external WLAN antenna
6
Protective earth (PE)
In addition to connecting the device via PROFINET and the available inputs/outputs,
additional connection options are also available:
• Integrate into a network via the service interface (CDI-RJ45) → 56.
• Integrate the device into a ring topology → 57.
Connecting the PROFINET connector
1.
3.
2.
4 x
TX 20
TX 20
22 mm
8.
24 mm
5.
6.
4.
≤
42 (1.6)
7.
A0033987
1. Loosen the 4 fixing screws on the housing cover.
2. Open the housing cover.
3. Fold open the terminal cover.
4. Push the cable through the cable entry . To ensure tight sealing, do not remove the
sealing ring from the cable entry.
5. Strip the cable and cable ends and connect to the RJ45 connector.
Summary of Contents for Proline Promag W 500
Page 262: ...www addresses endress com...
