Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 118 / 198

Operation Proline Promag W 400 HART
118 Hauser
11.4.4 Output values
The Output values submenu contains all the parameters needed to display the current
measured values for every output.
The parameters displayed depend on:
• The selected device order
• The set operating mode of the pulse/frequency/switch outputs
Navigation
"Diagnostics" menu → Measured values → Output values
‣
Output values
Output current 1 →  118
Measured current 1 →  118
Pulse output 1
→  118
Output frequency 1 →  118
Switch status 1 →  118
Output frequency 2
→  118
Pulse output 2 →  118
Switch status 2 →  118
Parameter overview with brief description
Parameter Prerequisite Description User interface
Output current 1 – Displays the current value currently
calculated for the current output. 3.59 to 22.5 mA
Measured current 1 – Displays the current value currently
measured for the current output. 0 to 30 mA
Pulse output 1 to n In the Operating mode parameter, the
Pulse option is selected.
Displays the pulse frequency currently
output. Positive floating-point
number
Output frequency 1 to n In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output. 0.0 to 12 500.0 Hz
Switch status 1 to n In the Operating mode parameter, the
Switch option is selected.
Displays the current switch output
status. • Open
• Closed
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using the Setup menu (→  83)
• Advanced settings using the Advanced setup submenu (→  101)