Endress+Hauser Deltabar FMD71, Description Of Device Parameters

Page: 13 / 68

Deltabar FMD71, FMD72 Operation with an operating menu
13
Write permission Operators/Service engineers/Expert
Description Use this function to enter a code to lock or unlock operation.
Entry • To lock: Enter a number
¹
the release code (value range: 1 to 9999).
• To unlock: Enter the release code.
Factory setting 0
Note The release code is "0" in the order configuration. Another release code can be defined in
the "Code Definition" parameter. If the user has forgotten the release code, the release code
can be visible by entering the number "5864".
The release code is defined in the "Code Definition" parameter.
Code Definition (023)
Navigation Setup → Advanced Setup → Code Definition
Read permission Operators/Service engineers/Expert
Write permission Operators/Service engineers/Expert
Description Use this function to enter a release code with which the device can be unlocked.
Entry A number from 0 to 9999
Factory setting 0
2.8 Resetting to factory settings (reset)
By entering a certain code, you can completely, or partially, reset the entries for the
parameters to the factory settings
1)
. Enter the code via the "Reset" parameter (menu path:
"Diagnosis" → "Reset").
There are various reset codes for the device. The following table illustrates which
parameters are reset by the particular reset codes. Operation must be unlocked to reset
parameters (see "Locking/unlocking operation" section (→  12)).
1) . The factory setting for the individual parameters is specified in the parameter description