WaterWell Manual Aquatic Treadmill
Supplemental Guide
Page 2 of 5
Endless Pools Inc.
3/2/2010
Grab Bar Installation
1.
Follow the installation instructions for your WaterWell up to step 9, “Optional Lights, Jet, and
Treadmill” found in the “WaterWell Installation, Operations, and User’s Manual.” If you intend to use
the mounting bolts to secure the grab bar bracket, then this will have to be done prior to installation of
the liner. Draw a level line 3/4” down from the top flange where you intend to place the grab bar
bracket. Align the top of the bracket with that line. Mark the 2 small outer holes of the bracket onto the
panel. Drill out these holes with a 3/8” drill bit. Then, continue with the installation of your WaterWell.
2.
Once the liner is in place and there is water in your pool, find the 3/8” holes in the panel and puncture
the liner at these points. The grab bar bracket will be secured to the pool wall via stainless steel nuts
and bolts. Push bolts through the liner from the inside out. Place the washer and nut on the bolt from
the outside of the pool. The larger inner holes of the bracket will be unused in this application.
3.
If you intend to use the stainless steel self-drilling screw and washer, then place the bracket in the pool
where you intend to place the treadmill. Note: the top of the bracket cannot be greater than 1” away
from the top of the panel. Make sure that the bracket is level and secure the bracket to the pool wall.
4.
Install the grab bar to the bracket with the provided nuts and bolts. There are several positions that you
can place the grab bar. Make sure that the bar will not interfere with any retractable security cover that
may have been purchased.
5.
Finally, install the grab bar cover to the grab bar bracket using the provided stainless steel machine
screws.
Grab Bar Bracket
