Prepare limit switch assembly (ZI) and
3mm Allen key
;
The direction of the base (Ba) stays at the
front, and the switch assembly (ZI) is mounted
on the left side of the base (Ba) (as shown in the
diagram on the)
;
Loosen the T-nut by hand until it is at the
end of the threads, but not so far it might fall off.
Then, fit into the slot in the aluminum profile.
When the bolt is tightened, the nut rotates 90
degrees and then grasps the inside of the slot.
Align the T-nut with the bottom
aluminum profile groove and secure with the
Allen key
The limit switch assembly (ZI) has a small
hook that attaches to the aluminum profile
underneath the base (Ba) (reference: about 32
mm from the bottom).
Fron
t
4