27
Notes:
1. Pay attention to the mounting orientation of the rack component, with the barrel facing backwards;
2. To lock the ship-type nut, it must be perpendicular to the p
rofile slot.
A.
Make sure that the V-wheels at both ends of the X-axis componen
t are fully seated in the Z-axis profile
slots;
B.
Align the screw with the T-bar nut, and adjust the X-axis component downwards by rotating the coupling
until the screw protrudes 20mm from the surface of the T-bar nut.
Install the X-axis components
A.
Place the top gantry profile on the profile to the left and right
of the Z-axis and lock it properly by aligning
with the holes from top to bottom with four M5x25 hexagonal cylindrical head spring washer combination
screws;
B.
Attach the 2 pcs of 20 profile end caps to each end of the top gantry profile.
Install the top gantry profile
A.
Loosen the nut on the barrel, thread the rack through the barrel hole, and tighten the nut again;
B.
Put the rack component on the top gantry profile and lock it in
place with two M5x8 hexagon socket
button head screws and two ship-type nuts.
Install the rack
Don't be too tight
Stepped
bore
a:Fasten it
b:Then embed it
