Setting Up
________________________________________________
Clamping
Assembly
Fit one M12 nut and washer onto each clamp rod selected for use, then
screw the pair of clamp rods into the location plate and tighten the
locknuts.
Place the two large plain washers over the 20mm threads of the clamp
sleeves. These can be seen protruding vertically from the two side lugs
on the clamp plate. Screw the two handwheels loosely onto the 20mm
threads, leave a gap of 3mm between the large washer and the
handwheel face. Do not tighten right down at this point.
See Diagram below:
- 4 -
