Wet Sieving Adaptor Kit
__________________________________
The wet sieving adapter kit is supplied as an optional extra for 8” or
200mm diameter sieves and should be ordered separately.
The wet sieving kit consists of the following items:
1 off
Special Wet Sieving Clamp Plate
1 set
‘O’ Ring Seals. One required for each sieve in the
stack.
I off
Special Wet Sieving Receiver.
(Specify for 200mm or 8 in. diameter sieves.)
1
off Nylon
Hosetail.
The Blanking Plug (12) at the rear must be removed and the nylon
hosetail fitted. The hosetail must have a suitable length of hose
fitted to drain into a convenient drainage point. The ‘O’ ring seals
are fitted on the outside of the bottom rim of each sieve so that
when the sieves are stacked onto each other they form a seal. The
bottom sieve is stacked on the special receiver with a spout. Fit a
suitable length of hose to the spout to drain into a convenient
drainage point. The clamp plate is usually supplied with the rose
reversed to avoid damage. Undo and reverse, so that the rose head
is on the inside. Remove the lid from the sieve stack and replace the
standard clamp plate with the wet sieving clamp plate. Fit a suitable
length of hose to the inlet of the rose on the clamp plate and
connect to the fluid supply with flow regulation.
- 14 -
