EDM 01-11v8 DAG 6.1S Card User Guide
©2005
19
Version 8: May 2006
4.7 Inspect 10G Ethernet Interface Statistics
, continued
WAN Statistics
For WAN mode, the following statistics are available.
RAI
Receive Alarm Indication. The optics report a
receive error. One or more of the following two bits
will also be set.
RLE
Receive Lock Error. The optics report a failure in
clock recovery from the received signal.
RPA
Receive Power Alarm. The optics report insufficient
optical input power (<-30dBm).
LOS
Loss Of Signal. The framer reports there is either no
signal at receiver, or optical signal strength is too
low to be recognized.
LOC
Loss Of Clock. The framer is not receiving a valid
clock from the optics.
OOF
Out Of Frame. The framer is not locked to the
SONET stream.
LOF
Loss Of Frame. The framer has asserted OOF for
more than 3 milliseconds.
LOP
Loss Of Pointer. The framer cannot find the
SONET/SDH frame pointers.
LOF
Loss Of Frame. The framer has asserted OOF for
more than 3 milliseconds.
BER
High Bit Error Rate detected, check optical level.
LFT
Local Fault, signal from peer is not being received
correctly.
RFT
Remote Fault, peer is not receiving a signal
correctly.
BER
High Bit Error Rate detected, check optical level.
LFT
Local Fault, signal from peer is not being received
correctly.
RFT
Remote Fault, peer is not receiving a signal
correctly.
FCS_ERR
Number of Ethernet FCS errors since last reading.
BAD_PACKET
Number of errored packets received since last
reading.
GOOD_PACKET
Number of correct packets received since last
reading.
RXF
Receive Fifo Errors. Number of Framer receive
FIFO errors since last reading.
Continued on next page
