Encore X-TREME 60K25X Operation Manual Download Page 6

ENCORE

6

BATTERY

The gel-cell battery is maintenance free.
For longest service life, battery should be 

kept clean by wiping it off with a paper 

towel.  Any corrosion around battery should 

be removed by applying a solution of one 

part baking soda to four parts water.  A light 

coating of grease or petroleum jelly may be 

applied to all exposed terminal surfaces to 

prevent corrosion.

 

CAUTION:

When  servicing  the  battery  or  any  other 

part of the electrical system, or if the battery 

must  be  removed  for  any  reason,  always, 

disconnect  negative  (ground)  cable  FIRST 

and reconnect it LAST to avoid possibility of 

electrical shorts.
At  temperatures  below  32°  F  (0°  C),  full 

charge state must be maintained to prevent 

cell  electrolyte  from  freezing  and  causing 

permanent battery damage.

 

CAUTION:

Batteries produce flammable hydrogen gas.  

Avoid creating sparks and open flames and 

do not smoke when working near batteries.

Battery electrolyte solution is poisonous 

and can be injurious to eyes, skin and 

clothing.  

IN THE EVENT OF AN ACCIDENT:  Flush 

affected area immediately with a solution of 

one part baking soda to four parts water.  If 

baking soda is not readily available, flush 

affected area with water.  Notify physician 

immediately.

LUBRICATION

There are 5 grease points on the X52. One 

on each caster, one on the caster swivel and 

one on the foot pedal pivot. These are all 

pre-greased from the factory. Environmental 

conditions may be cause to vary frequency.

Before each use:

 

Clean engine chaff screen

 

Check engine oil and tire pressure

Every 40 hours:

 

Lubricate Casters (3 Pumps)

 

Lubricate Deck Height Foot-Pivot   

 

(1 Pump)

Every 100 hours:

 

Lubricate Caster Swivels (3 Pumps)

 

Lubricate drive and pump control pivot  

 

points

 

Check belt tension

BELT ADJUSTMENT

Remove key from the ignition switch.

  The 

deck drive belt, which may be accessed 

by removing the deck plate, (see fig.3) has 

a turnbuckle assembly  to adjust spring 

tension.  Spring tension should be maintained 

at 4” of spring stretch measuring the spring 

coils.  By turning the turnbuckle clockwise it 

will increase tension, counter-clockwise will 

decrease tension. 

BELT TENSION 

TURNBUCKLE

Fig. 3 - Turnbuckle Location

Summary of Contents for X-TREME 60K25X













Reviews: