ENCORE
4
CAUTION:
Always remove the key and set the
parking brake when leaving the machine
unattended, even for just a few minutes.
PREVENT ACCIDENTS:
Do not give
children or unauthorized persons an opportunity
to operate this machine.
TO START ENGINE:
occupy seat, set park
brake, leave the motion control levers swung
out, move throttle control lever halfway to
operating position. Turn ignition key to
start position to engage starter, release the
key when engine starts. Ignition switch is
spring loaded and will return to run position
automatically.
Slowly return choke to run position once the
engine has started.
STOPPING ENGINE
TO STOP ENGINE:
move throttle lever to
idle position and turn ignition key to “OFF”
position. If engine has been working hard or
is hot, allow engine to idle for a short period of
time before turning off key. This practice will
help cool engine before stopping.
IN CASE OF EMERGENCY
engine may
be stopped by turning ignition key to “OFF”
position.
STARTING ENGINE
(contiuned..)
SAFETY INTERLOCK SYSTEM
Your Encore Rider is equipped with a
Safety Interlock System that is designed
to help prevent possible serious injuries.
Understanding and maintaining this system is
vital, for maximum safe operation.
TO START ENGINE:
1. Blades (PTO) must be “OFF”.
2. Control levers in neutral
(swung out).
3. Park Brake “ON”.
4. Operator in seat.
THE ENGINE WILL KILL IF:
1. The operator leaves the seat with:
a. The control levers out of neutral
(swung in).
b. The blades on (PTO).
c. The park brake is “OFF”.
d. All the above.
2. The park brake is set before the
control levers are in neutral
(swung out)
CORRECT TRANSMISSION
OPERATION TO GO
FORWARD OR REVERSE
The Encore Rider is equipped with a separate
pump and wheel motor for each wheel and are
controlled with “Motion Control Levers” , one
for each wheel.
To go FORWARD, push both levers
forward evenly.
To go in REVERSE, pull back on both
levers evenly.
To CHANGE DIRECTION, slowly
move levers to neutral and move the
lever forward in the direction you want
to go.
The further the levers are moved away
from the neutral position, the faster the
machine will travel. To turn the Rider
left or right, slow the speed of the
wheel in the direction you want to turn.
To STOP the Rider, return both levers
evenly to the neutral position.
WARNING:
THE ENGINE EXHAUST FROM THIS
PRODUCT CONTAINS CHEMICALS
KNOWN IN THE STATE OF CALIFORNIA
TO CAUSE CANCER, BIRTH DEFECTS
OR OTHER REPRODUCTIVE HARMS.
MOWING SPEED
The Encore Rider is designed to operate
most efficiently at maximum blade speeds.
Summary of Contents for X-TREME 60K25X
Page 1: ...OPERATORS MANUAL 60K25X...
