Encore ENDSL-4R5G, User Manual

Page: 60 / 125

59
www.encore-usa.com
Field Description
the Internet normally, you must add a route on the
uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is required to enable NAPT.
Enable IGMP Enable or disable IGMP.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, which is
provided by your ISP.
Password
Enter the correct password for PPP dial-up, which is
provided by your ISP.
Type
You can select Continuous , Connect on Demand ,
or Manual .
Idle Time (min)
If you select Connect on Demand , you need to enter
the idle timeout time. Within this preset minutes, if the
router does not detect the flow of the user
continuously, the router automatically disconnects the
PPPoE and PPPoA connection.
WAN IP Settings
Type
You can select Fixed IP or DHCP .

If you select Fixed IP , you need to enter the local
IP address, remote IP address and subnet mask.

If you select DHCP , the router is a DHCP client,
the WAN IP address is assigned by the remote
DHCP server.
Local IP Address
Enter the IP address of WAN interface that is
provided by your ISP.
Remote IP Address
Enter the gateway IP address that is provided by your
ISP.
Net mask Enter the subnet mask of the local IP address.
Unnumbered Select it to enable IP unnumbered.
Add
After configuring the parameters in this page, click it
to add a new PVC setting into the Current ATM VC
Table .
Modify
Select one PVC settings in the Current ATM VC
Table , and then modify the parameters of this PVC.
After setting, click it to take this PVC setting into
effect.
Current ATM VC Table
This table shows the existed PVC settings. It shows
the Interface name, channel mode, VPI/VCI,
encapsulation mode, local IP address, remote IP
address and other information. The maximum item of
this table is eight.