Phono
NOTE:
-
Remove the stylus (needle) protector.
-
Securing the tone arm to the arm rest there is a little clip. Be sure to raise the clip
from the tone arm before playing. When not playing, snap the clip back over the
tone arm to keep it secure.
1. Select the function selector(12) to “ Phono “ position.
2. Set the speed selector(22) to the proper position depending on the record to be played.
3. Place the record on the platter (turntable). Use the spindle adaptor(22) if necessary.
4. Lift the tone arm from the rest(23) and slowly move toward the record. The platter will start to
rotate.
5. Place the tone arm at the desired position of the record.
6. Adjust volume up/down(7) to the desired volume level.
7. At the end of record, the platter will automatically stop rotating. Lift the tone arm from the
record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
NOTE: Some records are out of the auto-stop area setting and the turntable will stop before the last song finishes
playing. In this case, select the auto-stop switch (27) to “ off “ position, then it will run to the end of the record but will
not stop automatically. You will need to stop the turntable by pressing the power button or change the auto-stop switch
back to “on” position. Then put back the tone arm back to the rest position.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
3. Unplug the unit from the electrical power outlet immediately in case of malfunction.
CLEANING THE UNIT
z
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
z
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
z
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
z
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
-6-
