Encore Networks BANDIT III, Quick Start Manual

Page: 5 / 16

BANDIT III Hardware Description
Page 5
Go to
Table of
Contents
Go to
Top
Doc
Go to
List of
All Docs
• If you ordered a chassis for DC power: A connector for DC input power (in addition to a
connector for AC input power)
• A V.90/V.92 modem port
• Four RJ45 10/100-Base-T Ethernet ports:
- One WAN port, typically used as the network uplink to the host
- Three LAN ports, typically connected to local IP devices
Note:
The three Ethernet LAN ports on the BANDIT III constitute a LAN switch; you can
use them to create a small network.
• An expansion slot for a card that provides an additional port. The expansion slot accepts
one of several expansion cards for specific interfaces:
- Ethernet port, for a DMZ LAN
- DB25 serial port, configurable as RS-232, RS-449, V.35, or X.21
- 56k CSU/DSU port
- T1/E1 CSU/DSU port
- Dual-port T1/E1 CSU/DSU port, with drop-and-insert capability
- A second wireless card; this can be the same type (CDMA, EVDO CDMA, GPRS GSM,
or EDGE GSM) as the internal wireless card or a different type from the internal
wireless card.
Note:
For more information about ports for the expansion slot, see Ports in the BANDIT
Products .
• An alarm port
• A DB25 serial port
1.1.2 BANDIT III Chassis with Ethernet Switch Module
The BANDIT III is also available with an Ethernet Switch Module (ESM) comprising six LAN
ports. This BANDIT III chassis is available for -12/-24 volts direct DC input power
(
Figure 1-7 ) or for 5 volts DC input power via the AC power adapter. The DC chassis can use
a failover DC and AC input power configuration.
Figure 1-7. BANDIT III Chassis, Rear Panel, Basic Model,
with Ethernet Switch Module, -12/-24 VDC Input Power
(or Failover -12/-24 VDC and 110/220 VAC Input Power)
Top Doc
Doc List
Module TOC