2.4.3 Power Cable Connection
1) Connect the DC red and black cable separately to the + and - power terminal on the
8808F Switch using a screwdriver as seen in the image below.
2) Turn on the power, check that the switches power LED is on, this signifies power is
connected properly.
3 F
UNCTION
C
ONFIGURATION
G
UIDE
3.1 Computer Requirements
• Make sure the management PC has already been installed with an Ethernet adapter
• Use a network cable to connect the Ethernet ports between the 8808F switch and Ethernet network
card of the PC (not the console port).
3.2 Set Up Network Connection
1) You need to set the IP address of the PC and the 8808F switch in the same network
segment. The default IP address of the switch is 192.168.1.200, and the network gate is
255.255.255.0.
2) You must connect the management PC for configuring the 8808F settings to LAN port T1
which is the management VLAN. By default, management VLAN is VLAN1, and each port
of the switch is VLAN1.
3) If you need to connect the remote network, please make sure the management PC and
the router can do the above tasks.
4) The 8808F switch can’t assign the IP address for the management PC, you need to set
the management static IP manually.
All Rights Reserved © 1997 - 2017 Enable-IT
™
, Inc. Page
!
of
!
11
49
