EMX Industries, Inc.
Tech support: 216-834-0761
3/5
CS202_Rev1.6_070119 [email protected]
Determine the location of where you intend to install the probe.
Read the following list of tips prior to beginning the installation process.
This will save you significant time in the long run.
•
The detector
’s
sensitivity is a function of speed and mass. The detection distance for a moving,
average size car or truck is approximately 12ft. at a speed of 5 mph. At higher speeds, detection
distance can exceed 12ft. as noted below.
•
The detector is sensitive to minute changes in the magnetic field around the probe. Power lines,
transformers, and other electrical devices located in the vicinity of the probe that produce
transients could cause disturbances in the magnetic field that may result in triggering the detector.
Avoid installation of the probe near these devices.
•
Do not install the probe or lead wire near or parallel to:
•
Low voltage lighting wires or in-ground power lines
•
Telephone lines or intercom systems
•
Electric motors or control relays
•
Overhead power lines, transformers or underground power lines
•
Cell phone towers, TV towers or communications links
•
Moving metal flagpoles, fences, gates or horses with metal shoes
•
Do not mount on any moving surface, such as bridges or walkways that may vibrate under traffic.
The probe must always be installed in such a way that it remains completely motionless.
Any movement will cause the probe to trigger.
•
Probes are available in various cable lengths, when possible select the appropriate cable length
for the installation. If it is necessary to extend the cable length (maximum 900 ft), use a high-
quality lead-in cable suitable for direct burial, and a high quality, watertight cable splice to prevent
moisture from entering the cable causing false triggering. Lead-in wire is available from EMX.
•
When there is a high incidence of damage from burrowing animals or other potential damaging
activities, it is recommended that the cable be placed in plastic conduit (1
.5” internal diameter
) to
prevent damage to the cable. Damage to the cable jacket may allow moisture to enter the cable
causing false triggering. When placing the probe in plastic conduit, use foam or tape to assure
that the probe does not move or vibrate. It is recommended that the conduit be sealed to prevent
water from collecting in the conduit.
Installation
Size of Moving Vehicle
Speed
Detection Distance
Average size car or truck
5 mph min.
12ft.
Average size car or truck
10-50 mph
Greater than 12ft.
Large truck or semi-truck Over 50 mph
Greater than 40ft.
Train
Any
100ft.
