Operating instruction for collet holder
Type Softsynchro
®
/ PGR
Edition: 01.04.2012
9
®
2.6.1 Cleaning directions
Clean the powRgrip
interface of the collet holder, i.e. with a
taper cleaner (see catalogue, chapter accessories) or with a
clean towel.
Degrease powRgrip
collet, dip in a clean, fat-dissolving and
oil-free solvent, i.e. alcohol, cleaning solvent.
Dry collet. Only use compressed air if it is clean and oil-free (no
maintenance unit done before).
Set collet into tool holder.
Degrease tool shank, by dipping into clean, fat-dissolving and
oil-free solvent, i.e. alcohol, cleaning solvent.
Insert tool into the powRgrip
collet.
When using a PGR-GB collet with integrated square, the tool
must be turned into position in order to be inserted into the
square of the collet.
Press in tool, using clamping unit as described in the operating instruction of the powRgrip
unit or pre-adjust the length as described in chapter
2.6.2, page 10.
