Title
LRP2000 Long Range Passive Reader/Writer
13
3.4
Power Supply Wiring
CAUTION:
The antenna cables must be properly connected to both
the controller and the antenna at any time that power is
applied to the controller. Failure to properly connect the
controller to the antenna can cause damage to the unit.
Connecting the controller to any antenna other than the
LRP2000 Antenna can not only damage the controller, but
can void the operator's authority to operate the LRP2000.
Back out the terminal screws on the terminal block of the power
supply and connect the spade lugs of Cable CBL-1474 to the
terminals according to Table 3.3. Strip 1/4 inch from the opposite ends
of the cable assembly and connect to the input power terminals
according to Table 3.3.
CAUTION:
Only after all internal connections are completed should
the LRP2000 Power Supply be connected to the AC
mains.
Figure 3-6. Input Power Supply Lugs
Figure 3.6 Shows the LRP2000 Power Supply and spade lugs.
