EMS 7000 IRIS +
7940 ENGINEERS GUIDE v2.2 – 13/04/10
14
Once the settings are as above, click on the ‘OK’ button then on the next window click on
the ‘OK’. Now Hyperterminal is configured.
5.3 To gain access to command menu press the enter key 3 times. The terminal display
should change to:-
COMMAND id, con,
txd, quit >
6. ID
6.1 The transmitter has an individual identification number, which is set from this
menu. This allows the transmitter to be added into the IRIS/7703 receiver with a
unique number. The default ID for the transmitter is 1846A. Under normal
circumstances this menu should not require changing.
6.2 The only time the default setting will require changing is if additional transmitter
units have been added to an existing installation. If this is the case a print out
should be taken from the IRIS Receiver and the transmitter ID settings checked.
The new transmitter can then be added to the system ensuring that the new ID
does NOT correspond with any already programmed into the IRIS unit. If a 7703
receiver is being used, additional transmitters when adding into the receiver, will be
shown as already in use if an ID code matches an existing transmitter. This is
shown by the Low Battery LED not flashing three times at the end of the adding
routine to show confirmation. The ID code will then have to be changed until the
transmitter is accepted. Section 12 shows in a step by step guide format how to
add a transmitter to a 7703 Receiver.
6.3 To change the transmitters identification number, from the command menu type
id
and press the
enter
key. The display will then show:
Current ID code (hex)
1846A
New ID code (hex)
To change the ID enter the new code in
capitals
(1846B for example) and then
press the enter key. If the hex number is a valid number the display will now
show:
New ID Code (hex) 1846B
COMMAND id, con
txd,quit >
