31792-4-1115
Page 34
REMOTE INSTRUCTIONS
The remote control and its LCD screen lets you make full use of
your fireplace’s potential. In particular it enables you to adjust the
fireplace’s operating parameters, program its timer, and continu
-
ously monitor room temperature to control operation.
A room temperature sensor is built into the remote control to en
-
sure accurate measurement of temperature in the room to be
heated, at whatever point the user wishes, and without having to
install inconvenient thermostat cables.
When the remote is turned on the back-lighting of the remote con-
trol screen illuminates as soon as you press any button.
A
C
D
E
F
G
B
Index
No.
Description
A
Temperature sensor location
B
Back-lit LCD display
C
Power button. Use this button to switch the remote On,
Off or place the remote in Standby (PILOT) mode.
D
The Mode Select (Manual - Thermostatic) button
switches the remote from Manual (MAN) mode to
Thermostatic (AUTO) mode. When using this button
in conjunction with other buttons you can also access
menus like the clock setting menu.
E
Use the up and down button for adjusting the flame
level and adjusting the sleep and timer settings.
F
MENU button for accessing sleep and program
menus.
G
Base and battery compartment.
Figure 49 - LCD Remote Control
ATTENTION
If the remote control is switched off because there are no bat-
teries in it, it cannot be used to control the fireplace and the
fireplace’s display panel must be used instead (see page 32).
When using the fireplace’s display panel for operation only key
functions remain enabled: on, off and manual control of the
flame levels.
CAUTION
Keep the remote control away from direct heat and water.
Keep the remote control away from children.
The remote control must always be kept near the fireplace (i.e.
within a radius of about 16 feet of it) to ensure correct transmis-
sion of measured temperature values.
