
43165-1-1221
Page 21
MILLIVOLT ALTERNATE ON/OFF SWITCH INSTALLATION (STANDARD SURROUNDS)
WIRING THE FIREPLACE
CAUTION
Disconnect remote controls if you are absent for extended
time periods. This will prevent accidental fireplace operation.
Installation of Alternate Surround Panel ON/OFF Switch
An ON/OFF switch and wire assembly is provided. They are
included in the instruction packet.
Do not cut wire or insulation on metal edges.
Contemporary Surrounds
1. Find the coiled low voltage wire assembly and ON/OFF
switch located in the instruction packet.
2.
Millivolt Valve
- Attach the flag terminal ends to the
“
TH/TP
”
and
“
TH
”
terminals on the front terminal block of the
gas valve.
See Figure 19.
“
IP
”
Valve
- Locate the two 5-1/2
inch
long black wires
connected to the ON/OFF switch. Disconnect these two
black wires at the green and white wire connections. Attach
the flag terminals (the low voltage wire assembly found in the
Instruction Packet) to the green and white wire connections.
See Figures 20 and 21.
3. Run the low voltage alternate switch wires to the right of
the surround panel. Use the top knockout location. Then
secure the wires with wire clips provided.
See Figure 18.
4. The included ON/OFF switch may be installed into the
right-hand corner of the surround. Using a screwdriver,
remove the knockout and snap the switch into place.
Attach the two wire terminals from the wire assembly
coming from the valve terminals.
ON/OFF
SWITCH
ASSEMBLY
WIRING FROM
GAS VALVE
BLOWER
CORD
Figure 18
5. Connect the low voltage wires from the gas valve to the
ON/OFF switch.
a. For millivolt valve connections,
See Figure 19.
b. For IP valve connections, locate the green and white wires
from the control module, then connect the switch wire flag
terminals to the green and white wire terminals.
See Figures
20 and 21.
Figure 19
OF
F
GREEN WIRES
WHITE WIRES
REMOVE BLACK SWITCH WIRES
Figure 20
OF
F
ATTACH EXTENSION SWITCH WIRES
Figure 21
6. Attach the surround assembly to the insert. Refer to the
installation instructions supplied with the surround.