![background image](http://html1.mh-extra.com/html/empire-comfort-systems/vfll38fp30l/vfll38fp30l_installation-instructions-and-owners-manual_2404004004.webp)
34846-2-1016
Page 4
•
WARNING:
Failure to keep the primary air
openings of the burner clean may result in sooting and
property damage.
•
WARNING:
Before installing in a solid-fuel burning
fireplace, the chimney flue and firebox must be
cleaned of soot, creosote, ashes and loose paint by a
qualified chimney cleaner.
• Ensure the air shutter is set to the specification. See
Figures 1 to 3 on this page and Tables 1 and 2 on
page 5.
• Ensure burner, venturi, and air shutter are free of dirt,
lint, animal hair (i.e. cat and dog) or anything that may
block the needed air flow. See Cleaning and Servicing,
page 26.
•
WARNING:
Do not allow fans to blow directly into
the fireplace. Avoid any drafts that alter burner flame
patterns. Pay particular attention to ceiling fans and
exhaust fans.
• Do not place debris, logs or other articles on burner.
• Avoid the use of scented air fresheners while the
fireplace is in operation. A residue can be produced
which may produce soot.
• Avoid the use of decorative or scented candles while
the fireplace is in operation. Soot may be produced
from the by-products of a burning candle. Some
candles also produce soot.
• Do not use rock wool (embers) with this fireplace.
• Annual inspection and cleaning by your dealer or
qualified service technician is recommended to
prevent malfunction and/or sooting.
• Install optional logs according to the installation
instructions. Do not alter log placement from the
prescribed layout in this manual. Only use Empire logs
specifically made for this fireplace.
• Verify the venturi tube is not bent or distorted. The
main burner orifice must be centered in the venturi
tube for proper combustion and to prevent sooting.
IMPORTANT SOOT PREVENTION STEPS
IMPORTANT NOTICE
INSTALLER - SERVICE PERSON - HOMEOWNER
SOOT MAY BE CREATED IF THE FOLLOWING DIRECTIONS ARE NOT FOLLOWED.
Verify the air shutter for the correct setting. Refer to
tables1 and 2 on page 5 for specific air shutter settings for
each model.
NAT Gas Models -
The air shutter setting must be 1/16" or
1/8". See Figures 1 and 2, and Table 1 on page 5.
Figure 1 (1/16" opening shown)
Test 1/16 or 1/8 air shutter setting with a round object
like a drill bit. The object should barely slide between the
opening. See Figure 2.
Figure 2 (1/16" opening shown)
LP Gas Models
- The air shutter setting must be "fully
open" or 1/4" open. See Figure 3 and Table 2 on page 5.
The air shutter setting must be set to the maximum opening.
NOTICE
:
Orifice shield removed for photo clarity.
Figure 3