40390-0-0119
Page 7
INITIALIzING THE SYSTEM
Install 4 AA batteries into the receiver located behind the wall
plate.
See Figure 5.
Note the polarity of battery and insert into
the battery bay as indicated on the Battery cover (+/-). Place the
3 position slider switch in the Remote position.
Insert paper clip, or other similar object into the hole marked PRG
on the receiver front cover. The receiver will beep three times to
indicate that it is ready to synchronize with a transmitter. Install
the 3 AAA type batteries in the transmitter. Push the ON button.
The receiver will beep four times to indicate the transmitter’s
command is accepted and sets to the particular code of that
transmitter. The system is now initialized.
TEMPERATURE INdICATION dISPLAY
With the system OFF, press the Thermostat Button and the Mode
Button at the same time. Verify that a C or F is visible to the right
of the Room Temperature display.
See Figures 8 and 9.
Figure 8 - Fahrenheit
Figure 9 - Celsius
USING THE REMOTE CONTROL (CONT'd)
TURN ON THE FIREPLACE
Press the ON/OFF Button. The Transmitter display will show all
active Icons on the screen. The fireplace main burner turns on.
A single beep from the Receiver will confirm reception of the
command.
TURN OFF THE FIREPLACE
Press the ON/OFF Button on the Transmitter. The Transmitter
LCD display will only show the room temperature and Icon.
See
Figure 10
. The fireplace burner turns off. A single beep from the
Receiver confirms reception of the command.
Figure 10