41978-1-1220
Page 52
TO TURN OFF GAS TO FIREPLACE
A. This appliance has a pilot which can be lit with the manual
on/off switch, a remote control, or by switching the remote
receiver switch to the “ON” position. When lighting the pilot,
follow these instructions exactly.
B. Before lighting smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas
• Do not try to light any appliance.
• Do not touch any electrical switch;
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only the remote control or manual remote receiver
switch to operate the gas valve. Never use tools. If valve
does not operate, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
FOR YOUR SAFETY READ BEFORE LIGHTING
MILLIVOLT PILOT LIGHTING INSTRUCTIONS
WARNING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
1. Set REMOTE/OFF/ON switch to OFF.
2. Turn off all electric power to the appliance if
service is to be performed (if applicable).
2. Remove the barrier assembly to gain access to the
control compartment.
4. Push in gas control knob slightly and turn
clockwise
to "OFF." Do not force.
5. Replace barrier screen.
LIGHTING INSTRUCTIONS
1. Stop! Read the safety information above.
2. Set REMOTE/OFF/ON switch to OFF.
3. Turn off all electric power to the appliance (if applicable).
4. Push in barrier screen at bottom and lift valve cover to
access valve.
5. Push in gas control knob slightly and turn clockwise
to "OFF."
NOTICE:
Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not force.
6. Wait ten minutes to clear out any gas. Then smell for
gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above. If
you do not smell gas, go to the next step.
7. Find pilot in center of firebox floor.
8. Turn gas control knob counterclockwise
to
"PILOT."
9. Push in control knob all the way and hold in.
Repeatedly push the piezo ignitor button until the
pilot is lit. Continue to hold the control knob in the for
about one minute after the pilot is lit. Release knob,
and it will pop back up. Pilot should remain lit. If it
goes out, repeat steps 5 through 9.
• If the control knob does not pop up when released,
STOP and IMMEDIATELY call a qualified service
technician or gas supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
10. Turn gas control knob counterclockwise
to
"ON."
11. Replace barrier screen.
12. Turn on all electric power to the appliance (if applicable).
13. Set REMOTE/OFF/ON switch to desired setting.