12
13
Flat SURFaCE MOUntInG
Disassemble the angled surface mount adaptor .
Mark and drill holes where you want to fix the tweeters . You can use the base cap directly as a
template . Three holes need to be drilled, one main hole for the cable routing and two small pilot
holes for fixing the base to the surface . You’ll need 2 .5mm and 6mm drill bits and a power drill .
After drilling the holes, mount the flat base cap to the surface, using the two self tapping screws con-
tained in the accessory set . Feed the tweeter wire through the center hole and connect the tweeter
extension wire to the tweeter extension wire . Place the upper ring shaped adapter over the tweeter
and press down to lock it in place .
RECESSED tWEEtER MOUntInG
After choosing a mounting location with at least 19 .5 mm clearance behind the panel, the tweeter
must be disassembled to find the best mounting location . Pre-drill small pilot holes on the driver and
passenger sides where the tweeters shall be mounted . The pilot holes must now be enlarged to 46 .5
mm diameter with a core drill . Reassemble the main tweeter unit into the recessed mounting adaptor .
Insert the tweeter assembly into the hole you have cut . Use the toothed ring to fix the tweeter in place
by pushing the toothed ring over the backside of the mounting adaptor . You can now connect the
tweeter extension wire to the tweeter main wires on the backside of the panel . Remount the panels,
you’re done .
