Tank Level and Pre-treatment Lockout Wiring
The Whole House RO system is equipped with two switch closure circuits that control the
RO system ON/OFF function. This is a "no voltage" switch closure circuit (dry contact).
Tank Level Input
There is a switch closure circuit used to turn some RO systems on and off when an at-
mospheric tank float is installed. The float switch wires as follows:
The wires above show color coatings. However, the colors do not matter. There is no volt-
age to these wires. They just need to be wired in a loop that can open or close when nec-
essary.
BE SURE
to use the blue and black wires only on the float.
IMPORTANT! Do not apply voltage to the tank level input circuit. This will damage
the RO system.
27
Summary of Contents for PWCRO
