4.3
Your Advanced UV will be wrapped as one cocoon of bubble
wrap. First, carefully remove the outer layer of bubble wrap. You
should now have two protected sections connected by the power
cord as shown in
Photo 4C
to the right. Second, carefully remove
the bubble wrap from the Advanced UV Sterilizer’s power supply.
Gently slide the protective tube from the Advanced UV’s Quartz
Sleeve for removal. Lastly, remove the rubber bands from the
power supply cord and the piece of tape holding the screws in
place (located on the connection assembly). With the exception of
the two mounting screws your Advanced UV Sterilizer should not
have any loose parts. If your Advanced UV does not look like the
one in
Photo 4A
, or if you noticed any broken parts please contact
Emperor Aquatics, Inc. at 610-970-0440 x0 for further assistance.
4.4
Your Advanced UV Sterilizer is now ready for installation into
your Savio Skimmer.
4C
5.1A
Slide the quartz sleeve end of the unit gently into the UV
chamber of the filter (shown in
Photo 5A
). Line up the two
screws of the white connection assembly with the holes on
the filter. Ignore the center hole.
5A
5.2
Secure the Advanced UV Sterilizer by tightening down the
two screws (shown in
Photo 5B
).
5B
4
5.0 Installation
5.1B 2008 and Newer Savio Skimmers
require the UV Plate
hole to be opened up from a 7/8” diameter to 1”. Use a 1” hole
saw bit to accomplish this. Center the 1” hole saw over the
existing hole, then carefully drill through the plastic unit com-
pletely. Make sure the freshly cut surface is smooth and clean
before proceeding.
Note: Using a quartz sleeve maintains the
critical operating temperature required
by the lamp for optimum UV-C output.
