21
Caution!
The sharp blade should always be protected by adjusting the cover (just push it with your
thumb).Injuries are possible so be careful when using this instrument-keep out of reach of reach of
children
!
Appropriate
light
cleaning or washing products are recommended, such as e.g. any kind of liquids or
emulsions for fat removal.
In
particular,
special
cleaning products such as COLLO Luneta, Sidol
Stahlglanz
,Stahl-Fix
for
washing and Cleaning and Cera
Fix for maintenance are recommended. If the
recommended products are not available, it is advisable to use a solution of warm water with a little
washing-up liquid or cleaning products for stainless steel sinks.
Oven
!The oven should be cleaned after every use. When cleaning the oven the lighting should be switched on
to enable you to see the surfaces better.
!The oven chamber should only be washed With
warm
water
and
small
amount of washing-up liquid.
!After cleaning the oven chamber wipe it dry.
Caution!
Do not use cleaning products containing abrasive materials for the cleaning and maintenance of the
glass front panel
!steam cleaning
﹡
:
-pour 250ml of water (1 glass) into a bowl placed in the oven on the first level from the bottom
-close the oven door,
-set
the
temperature
knob
to
125
℉
and the
function
knob
to
the
bottom
heater position
-heat the oven chamber for approximately30 minutes
-open
the
oven
door,
wipe
the
chamber inside with a cloth or sponge and wash using warm water with
washing-up liquid.
Caution!
Possible
moisture
or
water residues under the cooker can result from steam cleaning
! After cleaning the oven chamber, wipe it dry
Replacement of the oven light bulb
In order to avoid the possibility of an electric shock ensure that the appliance is switched off
before replacing the bulb
! Set all control knobs to the position
“
OFF”/ “STOP” and disconnect the mains plug
!unscrew and wash the lamp cover and then wipe it dry
!unscrew the light bulb from the socket
replace the bulb with a new one-a high temperature bulb (
575
℉
) with the following parameters:
-voltage 220~240 V~
-power 15 W
-thread E14
! Screw the bulb in, making sure it is properly
Inserted into the ceramic socket
! Screw in the lamp cover.
