EMOTION Optimus 170 Premium left, Operating And Installation Instructions

Page: 15 / 18

15
• wire stripping length of the cable ends: 6mm
• When conductors made of thin wires are used, ferrules may be used in conjunction
• The protective ground conductor is to be held long enough, that it is pulled out of the
terminal after the main wire when failure of the strain relief occurs
•
Only connect conductors on the designated contact points according to the wiring
diagram.
• Ensure the connectors make good contact (ferrule insulated conductor ends must be
inserted completely into the terminal, tensile test, particularly with the protective
ground wire.
• No “conductor reserves” (chafing, too long stripped individual wires etc.) to be stored
in the controller housing
•
Verify correct connection of the entire machine afterwards. Faulty connections may
interfere with the operation of the machine or may limit the inherent safety
measures!
In order to meet the requirements of the protective measure IP55:
•
The outer covers of the conductors (cladding) must be inserted completely into the
cable gland.
•
The cap nuts of the cable glands must be tightened in the correct way (open ended
spanner)
• Non-utilised mouthpieces must be closed of or, if applicable, replaced with insulation
blank-offs
•
Conductor mouthpieces must be arranged facing downwards or, if applicable,
sideways.
• The case cover must be fitted again correctly.
All conductors leading to the controller must be of sufficient length that all electronic parts
can be easily accessed and removed during repairs. When routing or affixing, care must be
taken that the insulation cannot be damaged by sharp edges or burrs nor by components
that may move or become hot.
The connection requirements of local energy suppliers and the additional requirements
related to the erection of high power voltage systems, in particular those for bathrooms,
must be strictly adhered to (protected area, potential equalisation etc) Germany DIN VDE
0100-701 (VDE 0100 part 701)