2
GB
Rechargeable LED lantern
The rechargeable lantern is resistant to rough conditions (dust,
dirt) and is therefore suitable for technicians, handymen and
cottagers, as well as for use in the car. The lantern has 3 power-
ful magnets and a hook for hanging. The bottom portion of the
lantern can be rotated 180°. The rear of the lantern is fitted with
a warning triangle. Its lighting is independent of the lantern
being turned on or off. The lantern can be used continuously
with a fully charged accumulator for approximately 2.5 hours
with COB LED and 25 hours with 5 LEDs. The lamp can be
charged, or recharged, from a 230 V~, 50 Hz network or from
a car socket with 12 V DC.
1. Switch
2. LED recharge indicator
3. Hook (360°)
4. Socket for charging
5. Switch – warning triangle
6. Magnet
Specifications:
Source of light: COB LED (450 lm) + 5× Ø 5 mm LED
Accumulator pack: Li-Ion 18650 – 3.7 V DC/2 000 mAh
Power adapter: type ZJF-DC090V300; input 230 V~, 50 Hz,
output 9 V DC/300 mA
Recharging from car: 12 V DC
Power adapter for car: car adapter, input: 12 V DC, output:
9 V DC/300 mA
Lantern operating temperature: -5 °C to +45 °C
Lantern charging temperature: +5 °C to +45 °C
Lantern size: 67 × 76 × 317 mm
Lantern weight: 537 g
Recharging the accumulator:
Before first use or if the lantern does not light up anymore, it
is necessary to charge the lantern. Charging a fully depleted
accumulator pack takes approximately 6 hours. Recharge the
lantern in dry indoor areas.
1. Connect the power adapter (type ZJF-DC090V300) to a
230 V ~, 50 Hz network.
2. Turn the switch on the lamp to the off position.
3. Connect the network power adapter into the lamp’s
power connector – a red light will turn on on the lantern.
When the lamp (accumulator) is fully recharged, the LED
will turn green.
4. After recharging, disconnect the adapter from the
lantern after 6 hours at the latest. The accumulator can
be recharged intermittently – it has no memory effect.
5. The lantern can also be recharged in a car – 12 V DC
through the lighter socket. Procedure for plugging in and
recharging is similar as when using a network adapter.
After recharging, disconnect the car adapter.
The lantern can also be recharged in a car – 12 V DC through
the lighter socket. Procedure for plugging in and recharging
is similar as when using a network adapter. After recharging,
disconnect the car adapter.
The lantern can be recharged using a car adapter only
when the vehicle is stationary and the engine is turned off.
Do not under any circumstances charge the lantern when
the car engine is running or the car is in motion.
The LED light sources have a 50 000 hour service life and
therefore are not replaceable. After exhausting, the entire
lamp can be disposed of.
