Emos H3016, Manual

Page: 7 / 48

7
• Do not replace any components of the product with non-original spare parts.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents – they could scratch the plastic
parts and cause corrosion of the electrical circuits.
• Do not immerse the product in water or other liquids.
• Keep the product and its power cord out of reach of children. This product may be used by persons with impaired physical, sensory
or mental capabilities or persons without experience and knowledge only if they are supervised or instructed in the safe use of
the product and understand the risks that may occur.
• Do not leave the product running unsupervised. Always disconnect the product from power if you are about to leave it unsupervised.
Delivery Contents
1× door camera unit
mounting screws
RFID keychains 125 kHz 5 pcs
Description of Terminals
see Fig. 1
Door camera unit
Monitor 1
1 – red – 12 V
2 – white – audio
3 – black – GND
4 – yellow – video
Monitor 2
5 – red/black – 12 V
6 – white/black – audio
7 – yellow/black – video
Monitor 3
8 – orange – 12 V
9 – grey – audio
10 – green – video
Monitor 4
11 – orange/black – 12 V
12 – grey/black – audio
13 – green/black – video
Voltage-free output
14 – light blue – NC
15 – blue/black – COM
16 – blue – NO
Output for lock 12 V
17 – purple – +12 V for lock
Button
18 – brown – EXIT button
Installation
Installation of the Door Camera Unit
see Fig. 2
Choose a suitable mounting spot and install the mounting frame.
Pull the power supply cable through the mounting opening and connect on the wires at the rear of the door camera unit.
Mount the connected door camera unit onto the mounting frame using the enclosed screws.
Door Camera Unit on Plaster
Apply a layer of silicone between the wall and the door camera unit to prevent ingress of humidity under the door camera unit. The
silicone should be applied on the top and the sides. The bottom side must be left open to allow humid air from exiting the space under
the door camera unit.
Setting Door Camera Unit Volume and Lock Relay Contact Time when Activated by the Exit Button
see Fig. 4
Values are set using the turn knobs on the back of the door camera unit (covered by a rubber seal).
Parameters of Interlinking Cables
For distances under 20 m, use a high-quality shielded FTP CAT.5 cable (optimally CAT.6). For distances over 20 m, we recommend a
SYKFY 5 × 2 × 0.5 or 10 × 2 × 0.5 cable. To achieve a higher cross-section, the cables can be doubled or tripled.