emmeti X-REVO-0919D, Use And Installation Manual

Page: 60 / 80

60
GB GB
8. USE THE AIR CONDITIONER
Models: Dual / Trial / Quadrial
The indoor units must be put into service in the same operational mode
or in compatibility mode according to the table below
Cooling Dry Heating Fan
Cooling
√ √
X
√
Dry
√ √
X
√
Heating X X
√
X
Fan √ √ X √
√
= Norm X= Interference
The outdoor unit always operates in the mode of the first indoor unittur-
ned/on. If a subsequent indoor unit is set in a way that interferes with
the first one, the unit that has caused the interference will be automa-
tically turned off.
8.3 Setting desidered temperature
Press
button to set desired temperature (with the appliance
switched off and without any preset timer).
flashes on LCD Display
Press , to increase temperature of 1 C°;
Press , to increase temperature of 1 C°;
Once the desired temperature is reached, it will flash for 3 seconds
before being confirmed.
The default temperature range is 18-32 ° C (in cooling, heating and
dehumidification mode).
In FAN ONLY mode it is not possible to set the temperature. The
default range can be changed by a qualified installer
The indicatore ‘Temperature Range Limit’ flashes when trying to
set the temperature beyond the default range (18-32 ° C).
8.4 Fan speed Setting
Press the FAN button to select the desired fan speed.
Each time the FAN button is pressed the speed changes in sequence:
In dehumidification mode the fan speed is automatically set to AUTO,
the FAN button is inactive.
8.5 Adjusting the air flow direction
(not valid for duct)
Press SWING button to select the air flow desired direction .
Each time the SWING button is pressed, the direction changes in
sequence (up / down (vertical);
right / left (horizontal); together vertical and horizontal):
7
available only for some models
8.1 On / Off
To turn on the air conditioner press the ON / OFF button, the ON light
(blue) lights up, the appliance starts.
To turn it off, press the ON / OFF button again, the ON light (blue) goes
off, the appliance stops.
Hold down the "ON / OFF" button for more than 3 seconds, the applian-
ce will go completely to a stop state (the indoor unit stops, the ON
timer cannot be used to switch it on, only manual start), the buzzer will
emit 4 beeps
The infrared remote control can control the wire control.
8.2 Setting the operating mode
Press the "MODE" button (with the appliance switched off and without
any preset timer), to select the operating mode.
Each time the "MODE" button is pressed, the operating mode changes
in sequence:
COOLING HEATING AUTO FAN ONLY DRY