9
©2020 EMist
®
is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMist-00054-20 - Ver. 072220
TIP:
IT IS GOOD PRACTICE TO FLUSH THE APPLICATION
SYSTEM EVERY 24 HOURS WITH CLEAN WATER. DO
NOT STORE CHEMICALS IN THE RESERVOIR WHILE THE
SYSTEM IS NOT IN USE FOR GREATER THAN A 24 HOUR
PERIOD.
TIP:
IT’S IMPORTANT TO FLUSH THE SYSTEM IN
BETWEEN USE OR WHEN SWITCHING CHEMISTRY TO
PREVENT RESIDUAL BUILD UP AND TO AVOID MIXING
CHEMICALS.
Changing Chemicals:
5. Maintenance & Cleaning
The system is designed to minimize maintenance and cleaning.
Tips:
Clear the system at least once a day by spraying clean
water through the system for at least ten seconds.
Keep batteries charged.
Inspect cable for cuts, tears or damage.
Inspect applicator for debris or damage.
•
•
•
•
Storage
Empty fluid or run until empty.
Insert at least 1 inch (2.5cm) of clean water in the
liquid tank.
Run the electrostatic sprayer for at least 45-60
seconds to flush active chemicals from the system.
Remove batteries and re-charge by placing on the
charger.
Wipe down exterior with water or alcohol to remove
dirt and soil.
Use the power indicator on the end of the battery to
determine the battery state of charge (5 bars = full
charge).
Insert battery covers back into battery compartment
slots to prevent foreign particles and moisture from
damaging battery contact connectors.
Coil the quick connect electro-fluid cable up neatly
and securely.
•
•
•
•
•
•
•
•
To flush the system, empty the liquid tank and fill with
at least 1 inch (2.5cm) of clean water.
Spray for at least 45-60 seconds to flush the previous
fluid from the system.
•
•
Battery Removal
Make sure the system is powered off.
Remove both battery covers by squeezing the
triangular pop-out portion of the covers and pulling
outwards.
When covers are off, a pull-tab will be visible to assist
in removal of the batteries.
Place batteries into charger to fully charge for next
usage. Each battery takes approximately 45 minutes
to fully charge.
•
•
•
•
CAUTION:
DO NOT STORE THE SYSTEM IN AN AREA
THAT MAY FREEZE (TO AVOID DAMAGE FROM LIQUID
REMAINING IN THE SYSTEM AND LINES). THIS WILL
VOID THE WARRANTY.
CAUTION:
TO PREVENT CROSS CONTAMINATION
OF CHEMICALS, YOU MUST PERFORM A FLUSH
ANY TIME YOU CHANGE THE TYPE OF CHEMICALS
BEING USED.
Flushing the Electrostatic Sprayer
