5
©2020 EMist
®
is a registered trademark of SanoTech 360, LLC. All rights reserved.
EMist-00054-20 - Ver. 072220
3. Assembly & Operating Instructions
The battery should be fully charged prior to the start of
a project.
Inspect the quick connectors for any debris or
damage prior to inserting.
The tab end of the battery includes a power meter to
show remaining charge (5 bars = full charge).
Two bars or less during startup may limit time of use
without charging.
The connector side of the battery enters the power
pack case.
Keep battery handle tab to the left as you insert.
The battery easily seats in the power pack. Over
applying pressure may make the battery difficult to
remove without tearing tab.
Insert battery cover (plastic cover is attached by
a lanyard).
a)
b)
c)
d)
e)
f)
g)
h)
Utilize liquids for duration of project or until refill is
required.
You may exchange tanks with different liquids at
any time.
e)
f)
Assembly Instructions and Tips
IMPORTANT:
DO NOT DROP TANK INTO THE TANK
WELL. CAREFULLY APPLY SLIGHT DOWNWARD
PRESSURE ON THE TANK AND TURN INTO THE
LOCKING POSITION.
IMPORTANT:
CAREFULLY APPLY SLIGHT
DOWNWARD PRESSURE ON THE TANK AND
TURN TO UNLOCK BEFORE LIFTING TO REMOVE.
CAUTION: TURNING OR LIFTING A TANK FOR
INSERTION OR REMOVAL WITHOUT APPLYING
SLIGHT DOWNWARD PRESSURE PRIOR TO
LOCKING OR REMOVAL CAN DAMAGE THE TANK
OR THE SYSTEM.
Tank Unlocked
Handle Alignment
Tank Locked
Handle Alignment
1. Rechargeable Battery:
The system uses up to two lithium-ion batteries.
Remove the vented cap, leaving strain filter in place.
Fill as needed and replace vented cap.
Tank does not need to be removed to fill.
Align the tank handle with manual identified on the
power pack top label.
a)
b)
c)
d)
2. Interchangeable One-gallon Liquid Tank:
Keep this tab to the left as
you insert the battery into
its compartment on the
power pack.
