14
PN 20009722 REV F, [08/01/2020]
FINAL ASSEMBLY
Assembly Instructions
1.
Install four fascia mounting bolts. See Figure 16.
a.
Locate supplied bolts and washers from kit bag.
b.
Place washers on bolts.
c.
Screw mounting bolt with washer into chassis
leaving approximately 1 in (25 mm) to hang fascia.
2.
Ensure white panel fasteners holding fascia polystyrene
are pushed firmly in, fasteners may have loosened in
transit. See Figure 17.
3.
Lift fascia onto chassis mounting bolts. Align key hole
brackets with mounting bolts. Slide fascia forward to
lock into position.
4.
Cassette 18 - 36 units, connect vane motor plug. Plug
into socket connection on chassis. Figure 19 Page 15.
A.
Ensure polarized connector (2 position) is in proper
orientation and connected.
B.
Route wires to prevent them from becoming
trapped, cut, broken or chaffed. See Figure 18.
5.
Cassette models CAW (Infrared handheld remote)
contain second cable connection to control box for
infrared unit mount control. See Figure 20 Page 15.
6.
Ensure polarized (10 position) connector is in proper
orientation and connected.
7.
Route wires to prevent them from becoming trapped,
cut, broken, or chaffed. See Figure 18.
8.
Tighten fascia up to Cassette chassis. Verify seal is
obtained between fascia and chassis, necessary to
prevent recirculation. See Figure 21 Page 15.
9.
With filter(s) in place, install inlet grille(s) onto fascia.
Figure 16 - Mounting Bolts
Figure 17
- Push In White Panel Fasteners
Figure 18 - Wire Routing
