BANJO PICKUP ROUND Page 3
Installation Instructions:
TO VOLUME/
OUTPUT JACK
FROM PICKUP
5) Output Jack/ Volume Installation
Install the Output Jack assembly as shown below. Slide the threaded
strip behind the lugs and tighten using the four screws provided.
Positive of both batteries facing out
6) Output Cable
Plug in the output cable as shown below. Be sure the wire colors
match the legend on the box. R(Red), B(Braid), W(White).
4) Preamp/Battery Holder and Battery Installation
Install the Preamp/Battery Holder as shown on the rods and
install two CR2032 batteries. Be sure the positive side of
both batteries are facing the Battery Holder spring terminal.
7) Wire it up
Route the cables as shown by paying attention to the wire
colors marked on the pickup, preamp/battery holder
PC Board, and volume/output jack.
R=RED WIRE
B=BRAID
W=WHITE
