Emerson unidrive m300, Quick Start Manual

Page: 14 / 36

14
Unidrive M300 Quick Start Guide
Issue Number: 4
If an external EMC filter is used, a delay of at least 50 ms should be incorporated to ensure spurious
trips are not seen. The leakage current is likely to exceed the trip level if all of the phases are not
energized simultaneously.
4.4 Control terminal configurations and wiring
This parameter is used to automatically setup the user programmable area in the level 2 parameter
set according to drive configurations. Other default values may also be changed by drive
configuration. Parameters are stored in EEPROM automatically following a configuration change.
Defaults are loaded before drive configuration changes are made. Defaults loaded are defined by
Defaults Previously Loaded (11.046).
Action will only occur if the drive is inactive, not in UU state and no User Actions are running.
Otherwise, the parameter will return to its pre altered value on exit from edit mode. All parameters
are saved if this parameter changes.
00.005 Drive Configuration
RW Txt PT US
OL
Ú
AV (0), AI (1), AV.Pr (2),
AI.Pr (3), Preset (4), Pad (5),
Pad.Ref (6), E.Pot (7),
torque (8), Pid (9)
Ö
AV (0)
RFC-A
Value Text Description
0 AV
Analog input 1 (voltage) Analog input 2 (voltage) selected by terminal (Local/
Remote)
1 AI
Analog input 1 (current) or Analog input 2 (voltage) selected by terminal
(Local/Remote)
2 AV.Pr
Analog input 1 (voltage) or 3 presets selected by terminal
3 AI.Pr
Analog input 1 (current) or 3 presets selected by terminal
4 Preset
Four presets selected by terminal
5 Pad
Keypad reference
6 Pad.Ref
Keypad reference with terminal control
7 E.Pot
Electronic Potentiometer
8 torque
Torque mode, Analog input 1 (current frequency reference) or Analog input 2
(voltage torque reference) selected by terminal
9 Pid
PID mode, Analog input 1 (current feedback source) and Analog input 2
(voltage reference source)
Unidrive M300 Quick Start Guide English Iss4.book Page 14 Wednesday, July 16, 2014 8:38 AM