21
MODEL SOLU COMP II
SECTION 5.0
PROGRAMMING THE ANALYZER
SECTION 5.0
PROGRAMMING THE ANALYZER
5.1 GENERAL
5.2 CHANGING
STARTUP SETTINGS
5.3 CONFIGURING AND RANGING THE OUTPUTS
5.4
CONFIGURING ALARMS AND ASSIGNING SETPOINTS
5.5
SETTING THE INPUT FILTER
5.6
CHOOSING TEMPERATURE UNITS AND MANUAL OR AUTOMATIC TEM-
PERATURE COMPENSATION
5.7
SETTING A SECURITY CODE
5.8
NOISE REJECTION
5.9
RESETTING FACTORY CALIBRATION AND FACTORY DEFAULT SETTINGS
5.10 SELECTING A DEFAULT SCREEN, LANGUAGE, AND SCREEN CONTRAST
5.1 GENERAL
This section describes how to do the following:
1.
configure and assign values to the current outputs
2.
configure and assign setpoints to the alarm relays
3.
set the sensor current input filter
4.
choose temperature units and manual or automatic temperature mode
5.
set a security code
6.
tell the analyzer the frequency of the ac power (needed for optimum noise rejection)
7.
reset the analyzer to factory calibration and default settings
8.
select a default display screen
Default settings are shown in Table 5-1 on the following page. To change a default setting, refer to the section list-
ed in the table. To restore default settings, see Section 5.9.
5.2 CHANGING STARTUP SETTINGS
When the Solu Comp II is powered up for the first time, startup screens appear that enable the user to make some
basic settings. If incorrect settings were made at start-up, they can be changed now.
