Emerson Rosemount 705, Reference Manual

Page: 25 / 70

Reference Manual
00809-0200-4705, Rev AB
Commissioning
May 2017
21
Commissioning
Section 4 Commissioning
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 21
Configuring the transmitter to communicate with the wireless network . . . . . . . . . . . . . . . . . page 22
Using AMS Device Manager to configure the transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 23
Using a Field Communicator to change parameters within the device . . . . . . . . . . . . . . . . . . . page 23
K-factor consideration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 23
Verifying operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 25
4.1 Safety messages
Instructions and procedures in this section may require special precautions to ensure the safety of the
personnel performing the operations. Information that potentially raises safety issues is indicated by a
warning symbol ( ). Refer to the following safety messages before performing an operation preceded
by this symbol.
Note
The Rosemount
™
705 Wireless Totalizing Transmitter and all other wireless devices should be installed
only after the Smart Wireless Gateway has been installed and is functioning properly.
Wireless devices should be powered up in order of proximity from the Gateway, beginning with the
device closest to the Gateway. This will result in a simpler and faster network installation.
Failure to follow these installation guidelines could result in death or serious injury.

Only qualified personnel should perform the installation.
Explosions could result in death or serious injury.

Before connecting a Field Communicator in an explosive atmosphere, make sure the instruments are
installed in accordance with intrinsically safe or non-incendive field wiring practices.

Verify the operating atmosphere of the transmitter is consistent with the appropriate hazardous
locations certifications.
Electrical shock could cause death or serious injury.

Use extreme caution when making contact with the leads and terminals.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: This
device may not cause harmful interference. This device must accept any interference received, including
interference that may cause undesired operation.

This device must be installed to ensure a minimum antenna separation distance of 20 cm from all
persons.