Rosemount LinkPro Operating Instructions
November 2017
Reference Manual
00809-0100-4570, Rev DA
Rosemount LinkPro Operating Instructions
174
Figure D-6. Wiring Diagram
A. Inside Rosemount LinkPro
B. Outside Rosemount LinkPro
C. To ADAM vonverter and GSM Modem
D. From power supply
E. To ADAM converter
F. 120
Ω
resistor
Connecting RS-485 Wires
To connect RS-485 wires to the Rosemount LinkPro:
1. Connect two wires to sockets “5” and “6” in accordance with
2. The Rosemount LinkPro is supplied with a 120
Ω
resistor between sockets “5” and “6” (as shown in
), Do not add another resistor.
3. Ensure there is another resistor on the far end of the RS-485 daisy chain bus.
D.5.3
Modem connection
Perform the following procedures to connect the modem to the system/computer. To install the SIM
card into the modem:
1. Insert the SIM card into the external SIM slot.
2. Slide the SIM lock switch to the left to lock and secure the SIM card.
Note
Do not create loops, sharp bends, or crimps in the cables.
The green LED indicator flashes in attempt to register to the GSM network. When the modem is
registered to a network, the green LED indicator is solid.
PS IN 4...20mA
6
RS-485
+
+
- -
+
-
+
+
- -
PS IN 4...20mA
+
-
RS-485
5
4
3
2
1
6
5
4
3
2
1
RS-485
D+ D-
PS
OUT
+
-
PS
IN
+
-
A
B
C
E
D
F
F
Summary of Contents for Rosemount 5708
