Use the following procedure and
Figure 3-2
to install the LCD display:
Procedure
1. If the transmitter is installed in a loop, then secure the loop and
disconnect power.
2. Required: Remove the transmitter cover on the electronics board side
(opposite the field terminals side). Do not remove instrument covers
in explosive environments when circuit is live.
3. Engage the four-pin connector into the electronics board and snap
LCD display into place.
4. Required: In order to meet explosion-proof requirements, reinstall the
housing cover and tighten so the cover is fully seated with metal to
metal contact between the housing and cover. After the cover is
seated properly, replace the flathead screw located on the bottom of
the housing cover.
Figure 3-2: Optional LCD Display
B
C
A
A. Electronics board
B. LCD display
C. Display cover
Quick Start Guide
September 2018
14
Rosemount 4088B MultiVariable Transmitter Quick Start Guide
Summary of Contents for Rosemount 4088B MultiVariable
Page 3: ...September 2018 Quick Start Guide Quick Start Guide 3 ...
Page 36: ...8 11 EU Declaration of Conformity September 2018 Quick Start Guide Quick Start Guide 37 ...
Page 38: ...September 2018 Quick Start Guide Quick Start Guide 39 ...
Page 40: ...September 2018 Quick Start Guide Quick Start Guide 41 ...
