Emerson Rosemount 1153 Series B, Reference Manual

Page: 32 / 64

Reference Manual
00809-0100-4302, Rev BA
January 2008
Rosemount 1153 Series B
3-8
Correction For High Line
Pressure (Rosemount
1153DB and 1153HB
Only)
Span
If a differential transmitter is calibrated with the low side at ambient pressure
but will be used at high line pressure, correct the span adjustment to
compensate for the effect of static pressure on the unit. If zero is elevated or
suppressed, also correct the zero adjustment. Correction factors, expressed
in percent of differential pressure input at end points per 1,000 psi static
pressure, are:
Range Codes 3
+1.5% of input/1000psi
Range Codes 4, 5, and 8:
+0.75% of input/1,000 psi
Range Codes 6 and 7:
+1.25% of input/1,000 psi
The correction procedure below uses the following example:
Range Code 5, calibrated at –100 to 300 inH
2
O, to be operated at 1,200 psi
line pressure. Note that steps 3–6 are omitted for ranges based at zero
differential pressure.
1. Calibrate the unit per preceding section to output =
4 mA at –100 inH
2
O and 20 mA at 300 inH
2
O.
2. Calculate correction factor:
3. Calculate zero adjustment correction in terms of pressure:
4. Convert pressure correction to percent of input span:
5. Calculate correction in terms of output span (mA):
6. Add the milliamp correction to the ideal zero output (4 mA). This is the
corrected ideal zero output:
0.75 %
1,000 psi
------------------------
⫻
1 200 psi 0.9% differential input = ,
0.9 %
⫻
100 inH
2
– O 0.9 inH
2
O
– =
0.9 inH
2
O
–
400 inH
2
O input span
--------------------------------------------------------------- 0.225 % span
–
=
0.225 %
⫻
16 mA span
–
0.036 mA
–
=
4.00 mA 0.036 3.964 mA = –