PACMotion™ PSD Installation and User Manual
Section 5
GFK-3168A
September 2020
Mechanical Installation
90
5.18
Service Interface (X11)
Operating, position control, and motion-block parameters can be set up by using the setup
software on an ordinary commercial PC (
PSD X11
Connect the service interface (X11) of the drive to an Ethernet interface on the PC directly or via a
network hub/switch, while the supply to the equipment is switched off.
Use standard Cat. 5 Ethernet cables for connection (in some cases crossover cables will also work).
Confirm that the link LED on the PSD (the green LED on the RJ45 connector) and on your PC (or
network Hub/Switch) are both illuminated. If both lights are illuminated, then you have a good
electrical connection.
Color
Name
Indication
Green
Link
On = receive signal valid
Yellow
Activity
Blink = Transmit or Receive packet
5.18.1
Pinout X11
Pin
Signal
Pin
Signal
1
Tr
5
n.c.
2
Transmit -
6
Receive-
3
7
n.c.
4
n.c.
8
n.c.
5.18.2
Service Bus Protocols X11
Protocol
Type
Connector
Modbus TCP
Service Bus
X11
Ethernet TCP/IP
Service Bus
X11
