Emerson Liebert XDR, User Manual

Page: 11 / 40

General Product Information
5
3.2.3 Unpacking the Module
Do not unpack the Liebert XDR before moving it to the installation location. Once at the installation
point:
1. Cut the banding and place all packaged modules on the floor for unpacking.
2. Unbend all metal tabs as shown in
Figure 5 .
Use any of these tools to unbend the tabs: flat-blade screwdriver, claw hammer, pliers or crowbar.
3. Remove the top cover from the package.
4. Remove the center top brace.
5. Remove and set aside the hardware and key package.
6. Remove side panels from package.
7. Remove top protective foam from the package.
!
WARNING
Risk of 130-pound (59 kg) module falling. Can cause equipment damage, personal injury or
death.
Do not leave a Liebert XDR standing unattended on its side or its end without adequate
support to prevent it from falling over. The Liebert XDR must be supported at all times or laid
flat on protective material until it is installed.
Two properly trained and qualified people are required to move the module.