Installation
4
3.0
I
NSTALLATION
3.1
Inspection
Upon receiving a Knurr DCM, examine the packaging for any signs of mishandling or damage. If any
damage is noted, notify your local Liebert representative and your carrier immediately.
Figure 2
Knurr DCM as shipped
3.2
Required Setup Equipment
Each Knurr DCM ships with all the tools necessary to remove the unit from the pallet. The tool kit,
(Part # 542665G1) contains the following tools:
• 1 M5 Allen Wrench
• 1 M6 Allen Wrench
• 1 Torx L Key ,T30
The following tools are required to set up a Knurr DCM:
• pallet jack or forklift
• utility knife or scissors
• 9/16" ratchet or wrench
• 6mm hex wrench
Tilt Indicator shows
whether the unit was been
tilted beyond the allowable
limit or mishandled during
shipping
Braces secure Knurr DCM
to shipping pallet; one at
each corner
Shrink wrap secures corrugated
corner protectors to the Knurr
DCM and shields the unit from
contact damage
Corrugated Corner
Protectors at each
corner
Part Number and
Serial Number
