Installation, Operation and Maintenance Manual
VCIOM-01494-EN Rev. 0
June 2022
27
OM1 Wiring Diagram
Section 6: OM1 Wiring Diagram
Section 6: OM1 Wiring Diagram
Figure 38
BLINKER
LOCAL SELECTOR
MONITOR RELAY RELAY
CLC1
CLC2
OPC1
OPC2
J8
G
RO
UND
(Note 1)
Remote Commands
(Note 2, 5)
(Note 6)
Output contacts
(Note 3)
Optional Module OM3
Output Contacts
(Note 4)
NOTES:
1) Power connection L1-L2 for V DC or V AC single phase motor supply: from 24 V to 48 V or
from 100 V to 240 V
Power connection L1-L2-L3 for 3 phase motor supply from 208 V to 575 V (Check on the
actuator label the correct voltage to be applied)
2a) Remote commands options: standard configuration
OP
CL
Internal supply 24 V DC
OP
CL
External supply 24/120 V AC or 24/120 V DC
2b) Remote commands options: 2 wires setting (to be configured)
Contact open for actuator closing
Contact close for actuator opening
Contact open for actuator closing
Contact close for actuator opening
Internal supply 24 V DC
External supply 24/120 V AC or 24/120 V DC
3) Contacts shown in intermediate positon CLC1-CLC2 end of travel signalling in CLOSING
Contacts shown in intermediate positon OPC1-OPC2 end of travel signalling in OPENING
4) Output contact rating: 240 V AC/5 A - 30 V DC/5 A - 120 V DC/0,5 A
Output contacts (when used) have to be feed with the same external voltage
5) Control command rating: 24 to 120 V AC or V DC
Control signal: minimum duration > 600 ms
Total current drawn for remote controls < 25 mA
6) Blinker or local selector monitoring function (when mod. OM3 is present) to be configured
OPTIONAL MODULE 4 - 20 mA (OM1)
AUXC1
AUXC2
AUXC3
AUXC4
Retransmission
position
Bluetooth
(OPTIONAL)
Additional contacts indipendent adjustable
along all the stroke (10 steps) (Note 8)
(Note 9)
4 - 20 mA / 0-10 V Position request
(Note 7)
7) Position request 4 - 20 mA or 0 - 10 V to be selected on (OM1)
8) Relay output contacts can be set normally (MAKE or BREAK)
Output contact rating: 240 V AC / 5 A - 30 V DC / 5 A - 120 V DC / 0.25 A
9) Position retransmission
4 - 20 mA
0 - 10 V
4 - 20 mA
+24 V DC
24 V DC (+/- 10%)
External supply
