Lock
Washer
Hex Nut
Deck Plate
Metal
Mounting Plate
UW/UWL
Tank
3/4" Screws (2)
Snap-Connect
Fitting (3 pieces)
Plastic Mounting Gasket
Equipment You May Need:
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this hot water faucet.
Make sure that all electrical wiring and connections conform to local codes.
A standard 120-volt grounded electrical outlet is required under the sink for the faucet’s electrical power.
The wall outlet powering the tank must have electrical power supplied to it continuously.
This outlet must be fused and should not be controlled by the same wall switch that operates a food
waste disposer, unless you have a SinkTop Switch
™
from InSinkErator
®
.
It is recommended that a dedicated control valve be installed on the cold water line supplying water
to this system.
If you suspect elevated levels of chlorine in your water, it is recommended to use our water
filtration system.
The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa).
If it does, this will prevent your unit from operating properly.
Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
Drill
T-fitting
Dedicated control valve
Adjustable wrench
Phillips and flat blade screwdrivers
Pencil
Tape measure
Level
Anchors for drywall
Hole saw
Basin wrench
Hole punch
If you intend to use the sprayer hole in your sink for your faucet, you may need a basin wrench and a
1/8" plug or a 1/4" cap (
not supplied
) for the faucet spray hose line.
See Step 1-B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄
4
" - 1
1
⁄
2
" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
WHAT YOU NEED TO GET STARTED
2
COMPONENTS IN THIS PACKAGE
